Assembly Instruction for Sit-Stand Monitor Arm (DW122)(DE122)

Gas Spring Aluminum LCD Monitor Desk Mounts

Warning Statements

	Prior to the installation of this product, the installation instruction must be read and completely understood. Failure to do so may result in personal injury, property damage or voiding of factory warranty.
	Do not install on a structure that is prone to vibration, movement or chance of impact. Reinforce the structure as required before installation.
	Recommended mounting surfaces: Wooden studs or solid-flat concrete. If the mount is to be installed on any surface other than wooden studs, use suitable hardware
	Pay attention to the weight capacity of the mount. Exceeding the limitation can result in function unworkable or even serious personal injury and property damage.
	Never operate the mount if parts are missing or damaged. Contact your local service center for warranty service.

Product Line Graph

Parts Included

Common Steps

Loosen clamp screw until enough space is left for the edge of the desk

Tighten clamp using clamp screw until mount is securely fastened to desk.

Adjust locating ring at proper height and screw up tight to hold the mount.Adjust aluminum support part above the locating ring and use a hex key to fix it.

Recessed surface installation: Put 4 spacers between faceplate and monitor. Install 4 screws through faceplate, spacers to monitor via mounting holes.

Installation Steps for Product DW122

Lift the spring arm along with the monitor and put it on the supporting part.

Installation Steps for DE122

Insert extension arms to the supporting part.

Lift the spring arm along with the monitor and put it on the extension arm.

Use a hex wrench to adjust the height tension of the gas spring arm, to keep different weight of monitors still at any position.

Use a hex wrench to adjust the damp for swiveling. Turn counter-clockwise to reduce damping and clockwise to increase damping

Insert cables into cable covers. Use cable clamp to limit cables close to steel pipe.